Home Job Listings Millwright needed immediately: APPLY HERE

Millwright needed immediately: APPLY HERE


Millwright needed immediately: APPLY HERE

Minimum Job Requirements:

Grade 12 with Mathematics & Science strong pref.
Section 13 Red Seal Millwright Trade Tested.
Minimum 5 years experience in a similar role.
N4 Electro-mechanical Certificate.
Siemens PLC.

Key Performance Areas:

Scheduled Maintenance:

Receive maintenance schedules, interpret instructions and plan maintenance and repair work.
Inspect tooling and determine spares and consumables requirements.
Generate job requisitions for scheduled maintenance.
Transport tools, equipment and spares to the work site.
Isolate equipment, perform lockouts and make the work area safe.

Breakdown Maintenance:

Attend to machine breakdowns of a mechanical/electrical nature for all equipment under engineering functional control.
Update the responsible person on progress of repairs.
Escalate the problem to the next level if necessary.
Capture all information.

Mechanical Maintenance:

Produce simple components by expert use of:

Drilling machine;
Milling machine;
Surface grinding machine; and
Electrical Discharge machine (EDM).
Perform basic and MIG/TOG welding of metals.
Grind tools and drill bits.

Maintain mechanical equipment:

Indirect and direct drives, pipe systems, static seals, bearings, brakes and clutches, direct drives, dynamic seals, heat exchangers and pressure vessels, lubricating systems, pumps, conveyor systems, compressors, fluid power/pneumatic/vacuum systems, gearboxes, safety valves.

Electrical Maintenance:

Design and construct Single/Three Phase Circuits.
Design and install Electrical Wire Ways.
Construct, commission and do fault tracing on low voltage reticulation networks (220Vac, 110Vac, 24DC).
Install or replace and commission electrical equipment (lighting systems; electrical cables and conductors; earth leakage unit in a low voltage circuit; metering units or measuring instruments; low and medium voltage transformers; batteries; electrical wire ways; direct current (DC) machines three phase AC electrical circuits, machines and control gear).
Wire and commission three phase electrical circuits.
Inspect and clean (electrical machines; enhanced safety apparatus; electrical motors).
Test and inspect a three phase industrial/commercial installation.
Inspect and maintain all electrical equipment.
Replace electrical equipment.
Fault find and repair (Domestic appliances; single phase alternating current (AC) systems; three phase voltage electrical circuits).


Mechanically cut, drill, punch and assemble fabrication materials using powered machinery.
Cut materials using the oxy-fuel gas cutting process (manual cutting).
Join metals using the resistance welding process.

Instrumentation Maintenance:

Construct Basic Electronic Circuits.
Install Instrument impulse lines.

Project Initiation:

Contribute to project initiation, scope definition and scope change control.
Participate in the estimation and preparation of cost budget for a project or sub-project and monitor and control actual cost against budget. Apply Now